Untersuchung stationärer und dynamischer Vorgänge bei der Teerentstehung in Biomassevergasern und Gasreinigungen mit Hilfe der kontinuierlichen Teeranalyse (eBook, PDF)
PAYBACK Punkte
0 °P sammeln!
Biomass is an option to use renewable energy for the generation of heat, power and secondary fuels to substitute fossil fuels. The thermochemical gasification is an alternative technology to conventional biomass combustion. Gasification technology can generate power with high efficiency even in small scale power plants. It gives the option to produce gaseous and liquid fuels or basic chemicals from solid biomass. The major obstacle for the application of biomass gasification is the high tar content of the generated gas. A number of different approaches in gasification and gas cleaning systems ...
Biomass is an option to use renewable energy for the generation of heat, power and secondary fuels to substitute fossil fuels. The thermochemical gasification is an alternative technology to conventional biomass combustion. Gasification technology can generate power with high efficiency even in small scale power plants. It gives the option to produce gaseous and liquid fuels or basic chemicals from solid biomass. The major obstacle for the application of biomass gasification is the high tar content of the generated gas. A number of different approaches in gasification and gas cleaning systems has been developed in the past. However, tar production in the gasification process and incomplete removal of tars by the gas cleaning systems are still problems preventing the technical and economical breakhrough of the biomass gasification technology. Due to these problems the determination of the tar content is important in terms of research as well as in industrial application. The established tar analysis methodes are based on wet chemical sampling and GC-analysis. They are able to give detailed information about the different tar species existing in the gas. However, realtime process monitoring by measuring tars continuously is not possible up to now. An online tar measurement method has been developed at the Institute of Process Engineering and Power Plant Technology (IVD) of the University of Stuttgart. The method is based on the comparison of the total hydrocarbon content in the hot gas and the corresponding value of the gas with all condensable tars removed. The hydrocarbon levels are measured by a flame ionization detector. The difference in the hydrocarbon levels corresponds with the tar concentration in the producer gas. The measurement system allows a sequential sampling from two sampling points, i.e. the producer gas before and after the gas cleaning system. One complete sampling and analysis run lasts two minutes, allowing a quasi online analysis of the tar concentration. This allows a continuous process monitoring. Different types of gasifiers, such as fixed bed gasifiers or fluidised bed gasifiers in laboratory, pilot- or industrial scale have been investigated with the online measuring system. Biomass in the form of pellets and wood chips was used as well as special fuels like sewage sludge or RDF. Experiments have been done by sampling in the raw gas of gasifiers as well as in the clean gas. This was in order to evaluate the performance of the tar analyser on the one hand and to increase the knowledge about the dynamics of tar generation in gasification processes and of tar reduction in gas cleaning devices on the other hand. The results of the measurings showed variable tar concentrations in a range of a few milligrams up to about 40 g/m³. Validation with other tar analysing methods was carried out to detect correspondence and differences. This allows the interpretation of the obtained results. The thesis gives a succesful demonstration of the online Tar-Analyser being a suitable instrument to be used in research and industry and finally to help to improve gasifier technology.
Dieser Download kann aus rechtlichen Gründen nur mit Rechnungsadresse in A, B, BG, CY, CZ, D, DK, EW, E, FIN, F, GR, HR, H, IRL, I, LT, L, LR, M, NL, PL, P, R, S, SLO, SK ausgeliefert werden.
Andere Kunden interessierten sich für
